Skip to main content
Whirlpool Home Appliances

What is an F20 or FH Error Code on my Front-load Washer

This error code indicates a water supply problem. 

Are both the hot and cold water faucets turned on?

Turn on the water. Check the household faucets to see if the hot and cold water faucets are turned on. Make sure to open both faucets completely for proper fill.
 
NOTE: Both hot and cold water must be connected to the washer supply and turned on. The washer will not properly operate with only one incoming source of water. The water valve inside the machine needs to have the “pressure” from both attached hoses in order for the washer to complete the cycle.
 
If a cold water wash is selected, the washer is designed to add hot water to keep the temperature optimal for cold wash performance (75°F +/-10°).If you want to save energy by not connecting to the hot water line (or only have access to a cold water line if connected in a garage, etc.), purchase a “Y-connector” and an extra inlet hose to connect the hoses to both sides of the water valve.
 
NOTE: If you choose to connect only to cold water, wash performance may be affected.
 
Hose Wall pic.JPG

Are the water inlet hoses kinked?

Straighten the water inlet hoses.

Are the water inlet valve screens on the washer clogged?

Turn off the water and remove inlet hoses from the inlet valves in the back of the washer. Inside the inlet valves are screens. Remove any accumulated film or particles from the screens. Reinstall hoses, turn on water, and check for leaks. See the Installation Instructions for details.

Hose Inlets.JPG

Is the water pressure less than 10 psi? 

If the water pressure is too low, the washer may not properly operate. To find out your exact pounds-per-square-inch (psi) value, contact your local water utility company.

Are you using HE High Efficiency detergent? 

Use only HE High Efficiency detergent. Using non-HE detergent, or more than the manufacturer's recommended amount of detergent, can cause excessive suds. The excess suds can prevent the washer from detecting the incoming water.

Concentrated detergents labeled 2x and higher will require a small amount of detergent based on load size. Always follow the manufacturer's recommendations.

Are you using flood-preventing devices that can shut off the water to the washer?


These hoses have a valve inside that will close if the water pressure is higher than two gallons per minute; this will shut off the water to the washer. If one of these hoses becomes loose, the water flow through the hose will increase and close the valve inside the hose, which will shut off water to the washer to prevent a possible leak or flood. If the hose is not loose, try taking the hoses back to the store for a replacement set.  

CLICK HERE for more information on use of flood safe devices

Removing the Error

To remove the error display, press Pause/Cancel twice.

HCZ_003_web_ENV1.gif

If Pause/Cancel does not work:

Unplug the washer or disconnect the power for one minute. 

Plug in the washer or reconnect the power.

Re-select the cycle and press Start. 

NOTES: 

On some washers, when the washer is started for the first time after this error code, it will begin to drain. You will not be able to pause or cancel the cycle for about 8 minutes while it drains. This is normal.

If the error remains on the display, and all of the other conditions above have been checked, call for service.

 

If you would like to download or view product literature for your appliance, please visit our Manuals and Literature page.