Is the drain hose installed correctly?
Verify that the drain hose is not too far down into the standpipe beyond the elbow which could cause siphoning, water to drain back into the tub or slow or no spin. The way the drain hose comes from the manufacturer is correct for standpipe or wash tub installation. The drain hose form SHOULD NOT be altered for standpipe or wash tub installation. Do not tape the drain hose to the drain pipe.
CLICK HERE for more information on the Drain Hose installation
Is the drain hose too high?
Make sure that the drain hose does not extend more than 8" (20.3 cm) into the Standpipe (Drainpipe) or laundry tub (typically up). Using the U-shape drain hose form (as described in the Installation Instructions), will provide the correct length of drain hose in the drainpipe or laundry tub.
Do not tape the drain hose to the drain pipe.
Is the drain hose kinked or clogged?
Make sure the drain hose is not kinked or clogged. Straighten the hose for adequate water flow. Remove any blockage from the drainpipe or utility sink.
Do you use High Efficiency detergent?
Use only HE High Efficiency detergent. Always measure detergent. If you have very soft water, you may need to use less detergent. Using non-HE detergent or more than the manufacturer's recommended amount of detergent can cause excessive suds. The excess suds can cause the washer to run at a reduced spin speed, resulting in very wet loads.
CLICK HERE for more information on using HE Detergent in your washer
Still need help? Call or schedule service.
You may need assistance from a qualified technician. Call 1-866-698-2538 or click below to schedule an appointment.