Skip to main content
Icon/Error Created with Sketch.
block.addtocart.title

block.addtocart.message


Product Help | Whirlpool

How to Move All - In-One Washer Dryer

 

 Possible Solutions

Transporting your All-in-One Washer and Dryer:

  1. Shut off the water faucet. Disconnect and drain water inlet hose.
  2. If washer/dryer will be moved during freezing weather, follow WINTER STORAGE CARE directions before moving.
  3. Disconnect drain hose from drain system and from back of washer/dryer.
  4. Unplug power cord.
  5. Place inlet hose and drain hose inside washer/dryer drum.
  6. Bundle power cord with a rubber band or cable tie to keep it from hanging onto the ground.


IMPORTANT: Call for service to install new transport bolts. Do not reuse transport bolts. Washer/dryer must be transported in the upright position. To avoid structural damage to your washer/dryer, it must be properly set up for relocation by a certified technician.

warning electric.jpg

Reinstalling and using washer/dryer again:

To reinstall washer/dryer after non-use, vacation, winter storage, or moving:

  1. Refer to Installation Instructions to locate, level, and connect washer/dryer.
  2. Before using again, run washer/dryer through the following recommended procedure: 
  • Flush water pipes and hose. Reconnect water inlet hose. Turn on the water faucet.
  • Plug in washer/dryer or reconnect power.
  • Run washer/dryer through HEAVY DUTY cycle to clean interior and remove antifreeze, if used. Use only HE detergent. Use half the manufacturer’s recommended amount for a medium-size load.

 

Still need help? Contact us or schedule service.

Please contact us or click below to make an appointment from our preferred list of service providers for service on your appliances.

United States
   

Interested in purchasing an Extended Service Plan?

Please click below to learn more on how you can save up to 25% on New Appliance Extended Service Plans within 30 days of your appliance purchase.

United States
 
  • Was this article helpful?