Skip to main content
Icon/Error Created with Sketch.
block.addtocart.title

block.addtocart.message


Product Help | Whirlpool

Not Spinning - Front Load Washer

Possible Solutions

Was Low or No Spin selected?

Cycles with lower spin speeds remove less water than cycles with high spin speeds. Use the recommended cycle/speed spin for your garment. If Low Spin or No Spin was selected, the washer might not remove enough water from the load. To remove extra water in the load, select the "Drain & Spin" cycle. The load may need to be rearranged to allow even distribution of the weight in the basket.

NOTE: Cycle settings are remembered from the last time that cycle is run and will be recalled when that cycle is selected again. Example: If a "Heavy Duty" cycle was chosen without spin, the next time that cycle is selected, the spin will be disabled.

Was a "Delicate" or "Hand Wash" Selected?

Spin speeds can vary by the cycle selected. Your washer is designed that in specific cycles, such as Delicate or Hand Washables cycles, the spin speeds are slower. In these cycles, more water is retained in the load at the end of the cycle to keep delicate fabrics from shrinking and wrinkling. 

CLICK HERE for more information on cycles and options

Do you use High Efficiency (HE) detergent?

Use only HE High-Efficiency detergent. Always measure detergent. If you have very soft water, you may need to use less detergent. Using non-HE detergent or more than the manufacturer's recommended amount of soap can cause excessive suds. The excess suds can cause the washer to run at a reduced spin speed, resulting in very wet loads.

CLICK HERE for more information on using High-Efficiency Detergent

Was only a single bulky item washed?

Consider adding more items to help balance the load during the spin.

CLICK HERE for more information on washing only a single bulky item

Is the washer overloaded?

The wash load must be balanced and not tightly packed. A large unbalanced load could result in a reduced spin speed, longer cycle times, and possibly wet clothes at the end of the cycle. Washing single items can be challenging to balance, resulting in extended cycle time. Wash multiple items rather than individual items to improve the ability to balance the load for the spin cycle.

How to level the washer:

The washer must be level.  If not, the load may become unbalanced, causing the machine not to spin correctly.  This can also cause the appliance to have excessive noise and/or vibration, especially during the Spin cycle. 

CLICK HERE for more information on leveling your washer

Is the drain hose installed correctly?

Check drain hose for proper installation.  Use the U-shaped drain hose form on the drain hose and securely attach to drainpipe (standpipe) or tub.  Check that only 4.5" (113 mm) of the drain hose is in the drainpipe (standpipe).  The drainpipe (standpipe) height requirements are 96" (244 cm) maximum and 39" (99 cm) minimum.  Make sure the drain hose is not kinked or clogged.

CLICK HERE for more information on Drain Hose installation

Still need help? Contact us or schedule service.

Please contact us or click below to make an appointment from our preferred list of service providers for service on your appliances.

Interested in purchasing an Extended Service Plan?

Please click below to learn more on how you can save up to 25% on New Appliance Extended Service Plans within 30 days of your appliance purchase.

United States

 

  • Was this article helpful?