Long Dry Time - HybridCare Dryer

HybridCare™ Heat Pump Technology

A typical dryer uses large amounts of energy, this dryer consumes a fraction of the energy in the form of hot, moist air. The HybridCare™ dryer is a ventless heat pump dryer that uses a refrigeration system to dry and recycle the same air. The laundry is dried at low temperatures.

CLICK HERE for more information on how HybricCare™ Heat Pump Technology works

Lint Screen Cleaning:

The lint screen will be located in the door opening of the dryer. A screen blocked by lint can increase drying time.

If you use fabric softener on a regular basis, your lint screen may have residue buildup that is typically not visible. This residue should be cleaned occasionally for better drying performance. After removing lint, scrub with a nylon brush and detergent to remove this residue.

Clean HybridCare™ Filter every 5 Loads

Clean the HybridCare™ Filter when the light comes on after every five cycles.

CLICK HERE for more information on cleaning the filter.

Is the Cooling Fan clean and free from obstructions?

The cooling fan screen is located on the back lower right of the dyer. Pull the dryer away from wall and vacuum cooling fan screen with a brush attachment. 

CLICK HERE for more information on cleaning the cooling fan.

Were you drying a large load?

A large load may not allow enough airflow for the clothes to dry normally. Separate the load for better results.

Did you use an Automatic or a Timed Dry Cycle?

CLICK HERE for more information on load size and using Automatic or Timed Dry cycles.